U. S. Solid normally closed (N/C) high pressure electric solenoid valve is constructed with a durable brass body, two-way inlet and outlet ports with three-quarter inch (3/4") female threaded (NPT) connections, and heat and oil resistant Viton gasket. Suitable for use with hot or cold water, gas, air, very low viscosity fluids (< 20 cst), oils and hydrocarbons, e.g., gasoline, kerosene, or diesel fuel. Suitable for outdoor use. Not for use underwater. Customers chose this general purpose valve for: do-it-yourself projects, moderate temperature applications, harsh chemicals, flow control for irrigation systems, reverse osmosis systems, or to control flow of propane gas.
Pipe Size: 3/4" (20 mm) flow aperture
Body Material: Brass
Gasket / Diaphragm / Seal: Viton
Operation Type: Semi-Direct Lift Valve
Operation Mode: Normally Closed
Electric Current: Alternating
Voltage: 110 volts
Voltage range: + or – 10%
Power rating: 10 VA
Pressure, Minimum: 10 PSI (0.1 MPa)
Pressure, Maximum: 232 PSI (1.6 MPa)
Flow capacity: 7.6 gallons per minute (GPM) of water at 60 oF with a pressure drop of 1 PSI
Flow value: 7.6 Cv
Temperature, Minimum: 14 degrees Fahrenheit (-10 degrees Celsius)
Temperature, Maximum: 248 degrees Fahrenheit (120 degrees Celsius)
Manufactured in China by U.S. Solid.
OVERHEATING WARNING: Not designed for continuous operation over 8 hours (not a 100% duty cycle). While energized, under normal operating conditions, solenoid valve will get HOT. The coil will reach a maximum temperature of about 176°F (80℃). If energized for more than 8 hours the coil may burn.
Attention California Residents:
This product contains chemicals known to the State of California to cause cancer, and birth defects or other reproductive harm.