INTRODUCTION
This U.S. Solid 3/4 in UPVC motorized ball valve has a lead-free, corrosion-proof body for water, seawater, wastewater, and dilute chemicals in pools, aquariums, hydroponics, irrigation, and water treatment. It is not for gas or oil. It drives fully open or closed in about 2 seconds, energizes to open, and auto-returns to the fully closed position on power loss, while the 5-wire design reports open and closed status to your PLC, controller, or panel. The IP68 PPO actuator runs on 24V DC and includes a manual override for power outages.
FEATURES
APPLICATIONS
SPECIFICATIONS
| Model | JFMSV90026 | Port Size | 3/4 in NPT |
|---|---|---|---|
| Valve Material | UPVC (lead-free) | Open/Close Time | 2 s or less |
| Working Voltage | 24V DC | Max Power | 12 W |
| Max Torque | 15 Nm | Orifice | 20mm |
| Max Working Pressure | 1.0 MPa (145 psi) at 20°C | Ambient Temperature | -15°C to 50°C (5°F to 122°F) |
| Media Temperature | 2°C to 90°C (36°F to 194°F) | Service Life | 50,000 cycles |
| Default State | Normally Closed | Wiring Type | 5-Wire Auto Return |
| Manual Override | Yes | Waterproof Rating | IP68 |
| Seals | EPDM, FKM, PTFE | Actuator | PPO engineering plastic |
DIMENSIONS
The following dimensions apply to model JFMSV90026. All dimensions are in mm unless otherwise specified.
| Model | JFMSV90026 | Material | UPVC |
|---|---|---|---|
| D1/D2 | 3/4" | d ± 0.3 | 20 mm |
| L1 ± 1 | 115 mm | L2/L3 ± 1 | 25.5 mm |
| E1 | 31 mm | H1 ± 1 | 141.2 mm |
| H2 | 32 mm |
WIRING INSTRUCTIONS
Connect red to the positive supply and black to the negative supply, with the external switch SW in series with the red-wire power circuit. When SW is closed, the actuator opens; after the valve reaches the fully open position, the internal feedback contact connects green to white, indicating the fully open position. When SW is open, the actuator closes; after the valve reaches the fully closed position, the internal feedback contact connects yellow to white, indicating the fully closed position. White is the feedback common and the green, yellow, and white wires must not be treated as ordinary power-input wires.