U.S. Solid 15 KW High Frequency Induction Heater 30-80 KHz, 16:1 Turns Ratio, 220V or 110V

When it comes to inductive heating, the USS-HFIH00001 High-Frequency Induction Heater is among the best. It adopts the latest MOSFET and IGBT power units and the latest frequency control methods and techniques, and provides high efficiency, low energy consumption and very high output power. Through this, it achieves efficient and quick heating of any targeted area, and is highly useful when heating metals.
It has a 100% load design, which means that it can work 24 hours without stopping. Should there be a problem, there is an infrared temperature detector which alarms the operator if the machine overheats, and it also allows easier temperature control and simplifies manual operation.

Specifications:
Input Voltage: Single Phase; 220 V or 110V
Max. Inductive Power: 15 KW
Max. Input Power: 7 KW
Fluctuating Frequency: 30-80 KHz
Output Current: 200-600 A
Max. Heating Temperature: 1200℃ (2192℉)
Time Settings: 01 to 99 seconds
Water Temperature Protection Point: 40℃ (104℉)
Flow Rate of Cooling Water: ≥ 7.5 L/min
Min. Water Pressure: 0.3 MPa
Head of Cooling Water: ≥ 30 m (98 ft)
Min. Wire Gauge: 9 gauge
Net Weight: 25 kg (55 lbs)
Product Dimensions: 22" x 9" x 19"
Turns Ratio(the ratio of the number of turns in the primary to the number of turns in the secondary): 16:1
Circuit Breaker: ≥ 40 A

Applications:
1. Brazing: Hybrid welding of different materials. Clean the surfaces to be used. Dimension of the workpiece should be less than 1.2" x 1.2" x 1.2".
2. Diathermy: The diameter of the workpiece should be less than 5 mm (3/16").
3. Sealing: This can be used to seal and cap different machines. Be aware of the metal type used in the seal.
4. Hardening: Many metals can be heat-treated to induce hardening. Most often, this process requires quenching right after heating, so have a quenching station available.
5. Annealing: Some heat-treated metals will end up softer. Be aware of the type of metal you are heat-treating; results can differ.
6. Soldering: Much like brazing, clean the surfaces to be used. Be aware that solder can melt very quickly.
7. Smelting: Many metals can be smelt, e.g., copper, silver, and gold.

Packing List:
1 x Induction Heater
1 x Foot pedal
3 x Fuse
4 x Clamps (stainless steel)
2 x Tubing (copper) to connect your own coil, each about 0.5 ft long
1 x Tubing (copper) to create your own coil, about 5 ft long
1 x Coil (copper), about 3.3 ft long
1 x Hose (rubber), about 32 ft long, 3/4" diameter

Notes:
1. A heating coil with diameter 30 mm and a 1.5 m M6 copper tube will be included for free. If you would like to order more heating coils or other dimensions, please contact us by emailing service@ussolid.com with your order number and the details of coil you need.
2. This machine cannot be used with a plug. A wire will be necessary to connect the machine to power source directly (the cross-sectional area of power line must be larger than 6 square milimeters.)
3. The water temperature must not be lower than 26℃ to prevent a large temperature difference from the ambient temperature, which will cause condensation on the water pipes to form water droplets.