U.S. Solid 25 KW High Frequency Induction Heater 30-80 KHz, 18:1 Turns Ratio, Three-phase 480V

Note: This machine can't be used with a plug, it need a wire to connect the machine to power line directly, the cross-sectional area of power line must be larger than 6 square millimeters.

Our high-frequency induction heaters are used to heat various metal objects in a non-contact state, concentrating the heating at the necessary location to achieve instant heating, which can save energy, protect the environment and improve efficiency.

SPECIFICATIONS
Brand: U.S. SOLID
Model: USS-HFIH00003-480V
Power Supply: Three phase 480V
Output Power: 25kW
Turns Ratio (ratio of primary coil turns to secondary coil turns): 18:1
Total Coil Length: 300-800mm
Total Length of Copper Tube: ≤1.5m
Inner Diameter of coil: ≤100mm
Frequency: 30-80kHz
Output Current: 200-1200A
Maximum Heating Temperature: up to 1800℃ / 3272℉ (depending on the workpiece and coil material)
Minimum Circuit Breaker Current: 40 A
Time Setting: 1-99 seconds
Cooling Water: 0.15-0.25MPa 25L/min, (the recommended parameters will have the best cooling effect, while others may also be feasible, please contact us first)
Minimum Cooling Water Temperature: 26℃ / 78.8℉ (to prevent excessive temperature difference with the environment, causing condensation in the water pipe and the formation of water droplets)
Cooling Water Temperature Protection Point: 40℃ / 104℉

OTHER MODELS

SELECTION INSTRUCTION 

Manual